Publicidad
Idiomas disponibles
Idiomas disponibles
,_CAUTION:
Do not operate
the mower
without
either the entire
grass catcher,
on mowers
so equipped,
or the deflector
shield
(S)in
place.
REVERSE OPERATION SYSTEM (ROS)
Your tractor is equipped with a Reverse
Operation System (ROS). Any attempt by
the operator to travel in the reverse direc-
tion with the attachment clutch engaged
will shut off the engine unless ignition key
is placed in the ROS "ON" position.
AI_WARNING:
Backing up with the at-
tachment clutch engaged while mowing
is strongly discouraged. Turning the ROS
"ON", to allow reverse operation with the
attachment clutch engaged, should only
be done when the operator decides it is
necessary to reposition the machine with
the attachment engaged. Do not mow in
reverse
unless absolutely
necessary.
USING
THE REVERSE
OPERATION
SYSTEM
-
Only use if you are certain
no children
or
other bystanders
will enter
the mowing
area.
1.
Move motion
control
lever to neutral
(N) position.
2.
With engine
running,
turn ignition
key
counterclockwise
to ROS "ON" posi-
tion.
3.
Look down and behind
before
and
while
backing.
4.
Slowly
move motion
control
lever to
reverse
(R) position
to start movement.
5.
When
use of the ROS is no longer
needed,
turn the ignition
key clockwise
to engine
"ON" position.
ROS "ON" Position
Engine "ON" Position
(Normal Operating)
TO OPERATE
ON HILLS
_WARNING:
Do not drive
up or down
hills with slopes
greater
than 15 ° and do
not drive across
any slope. Use the slope
guide provided
at the back of this manual.
• Choose
the slowest
speed
before start-
ing up or down hills.
• Avoid stopping
or changing
speed
on
hills.
• If stopping
is absolutely
necessary,
push
clutch/brake
pedal quickly
to brake posi-
tion and engage
parking
brake.
• Move motion control
lever to neutral
(N)
position.
IMPORTANT:
The motion
control
lever
does not return to neutral
(N) position
when the clutch/brake
pedal is depressed.
• To restart
movement,
slowly
release
parking
brake
and clutch/brake
pedal.
• Slowly
move motion
control
lever to
slowest
setting.
• Make all turns slowly.
TO TRANSPORT
When pushing or towing your tractor, be
sure to disengage transmission
by placing
freewheel control in freewheeling
position.
Freewheel control is located at the rear
drawbar of tractor.
1. Raise attachment
lift lever to its highest
position.
2. Pull freewheel control out and into the
slot and release so it is held in the
disengaged position.
• Do not push or tow tractor at more than
two (2) MPH.
• To re-engage transmission,
reverse
above procedure.
Transmission
Engaged
Transmission
Disengaged
NOTE:
To protect
hood from damage
when
transporting
your tractor on a truck or a
trailer, be sure hood is closed and secured
to tractor.
Use an appropriate
means of
tying hood to tractor
(rope, cord, etc.).
13
Publicidad
