Audi 8V3.071.126 Instrucciones De Montaje página 32

Installation instructions - Audi A3 (8V3) 2012 ▶
Edition 06.2012
4.1.1 Installing the front roof bar — for vehicles
with „bright moulding package" and vehi-
cles with „black moulding package"
– Unhook the top claw fastener -12- from the installation posi-
tion on the support bracket- 9- and swivel down.
– Check the exact installation position of each roof bar!
● The positioning bolt -Z- of the claw fastener -12- must be
positioned precisely below the decorative roof trim mounting
hole -X-.
– Move the roof bar forwards or backwards if necessary.
Caution
The positioning bolt -Z- of the claw fastener -12- must be
positioned precisely under the mounting hole -X-.
– Carefully slide the claw fastener -12- upwards, guiding the
positioning bolt -Z- into the mounting hole -X- on the decora-
tive trim as you do so. Hold the claw fastener in this position
and gently tighten the bolts -13- using the torque wrench
-15-.
Caution
If the claw fastener -12- will not easily slide upwards, check
the position of the roof bar and correct it.
– Follow the same procedure on the opposite side.
– Install the rear roof bar
vehicles with „bright moulding package" (4ZB)" on page 11
⇒ „ Installing the rear roof bar — for vehicles with „black
or
moulding package" (4ZE)" on page
10
4 Installing/removing roof bars on vehicle
⇒ „ Installing the rear roof bar — for
12.