Audi 8V3.071.126 Instrucciones De Montaje página 35

– Gently tighten the bolt -13- using the torque wrench -15-.
– Follow the same procedure on the opposite side.
⇒ „ Securing the front and rear roof bars
– Tighten the roof bars
— for vehicles with „bright moulding package" (4ZB) and ve-
hicles with „black moulding package" (4ZE)" on page
4.1.4 Securing the front and rear roof bars — for
vehicles with „bright moulding pack-
age" (4ZB) and vehicles with „black mould-
ing package" (4ZE)
– Align the roof bars laterally — make sure they sit correctly
on the roof edge -arrow-.
The gap -a- must not exceed 1 mm.
If the rubber supports on the support bracket housing are not
flush to the surface, we recommend that you have the width ad-
justment checked and corrected by a qualified workshop
ting the roof bar width" on page
fore doing so.
Installation instructions - Audi A3 (8V3) 2012 ▶
13.
⇒ „ Set-
16. Remove the roof bars be-
Edition 06.2012
4 Installing/removing roof bars on vehicle 13