To maintain the softening function, the appliance periodically regenerates the water
softening system. Each regeneration requires an additional 2 litres of water, energy
consumption increases by 0.02 kWh and the program is extended by 4 minutes.
4.2 Filling/topping up regenerating salt
Add regenerating salt before using the appliance for the first time. Observe the following
when filling the salt container:
Only use regenerating salts specially made for dishwashers.
The manufacturer will decline all liability for damage caused by the use of
unsuitable salts and the warranty will be voided.
Fill in regenerating salt before putting into operation.
When using multi-tab detergent with regenerating salt, it is not
necessary to add regenerating salt.
Do not pour in regenerating salt if the water hardness in the
residential area is 0-5° dH.
13. Remove the lower basket and unscrew the lid of the salt container.
14. When using for the first time, fill the salt container with approximately 1 litre of
water.
15. Position the funnel and pour in approx. 1.5 kg of regenerating salt. It is normal
that a certain amount of water runs out of the container as the salt is added.
16. Absorb spilt regenerating salt immediately with a damp cloth.
17. Fit the cover correctly and screw it on as far as it will go.
18. Start a washing programme immediately after filling.
Normally, the low-salt indicator switches off after running a washing programme.
Fill up with regenerating salt when the "Salt indicator"
ATTENTION
APPLIANCE DAMAGE!
Never pour detergent into the salt container. Damage to the water softening
•
system.
Take care never to put the wrong powder in the salt container. A defect of the
•
water softening system is likely.
•
Tighten the salt container lid properly. If dishwasher detergent penetrates the salt
container, the water softening system will be damaged.
•
Do not leave spilled regenerating salt in the appliance. This will damage the
appliance.
Seite | 40
4
Putting the appliance into operation
lights up.