Publicidad
Idiomas disponibles
Idiomas disponibles
continuous operation. The edge of the anti-splinter guard
now corresponds exactly to the cutting edge of the blade.
To trim the anti-splinter guard on the other side of the guide
rail, remove the saw from the rail and rotate the rail 180°. Repeat
steps 1 through 4.
nOTE: If desired, the splinter guard can be bevelled to 45°, then
repeat steps 1 through 4. This allows one side of the rail for
cutting parallel cuts and the other side of the rail is tuned in for
45° bevel cuts (Fig. H).
nOTE: If the anti-splinter guard is trimmed for parallel cutting
on both sides, then when the unit is bevelled, the blade will not
run true to the edge of the anti-splinter guard. This is because
the pivot point of the unit bevel is not stationary and the blade
moves out when the unit is bevelled.
WARNING: To reduce the risk of injury, ALWAYS secure the
guide rail with a clamp.
Speed Adjustment (Fig. A)
The speed can be regulated between 2500 and 4200 rpm using
19
the speed wheel
. This enables you to optimise the cutting
speed to suit the material. Refer to the following chart for type
of material and speed range.
Type of Material to be Cut
Solid wood (hard, soft)
Chipboards
Laminated wood, blockboards, veneered and coated boards
Paper and carton
Door Cutting (Fig. I)
1. Place the plunge saw with the outer guard
flat floor.
4
2. Press the shoe
with the front side on the door against the
adjusted depth stop.
Dust Extraction (Fig. A)
WARNING: Risk of dust inhalation. To reduce the risk of
personal injury, ALWAYS wear an approved dust mask.
Your tool is fitted with a dust extraction outlet
The Dust Extraction Adaptor allows you to connect the tool to
an external dust extractor, either using the AirLock™ system
(DWV9000-XJ), or a standard 35 mm dust extractor fitment.
WARNING: ALWAYS use a vacuum extractor designed
in compliance with the applicable directives regarding
dust emission when sawing wood. Vacuum hoses of most
common vacuum cleaners will fit directly into the dust
extraction outlet.
MAINTENANCE
Your D
WALT power tool has been designed to operate
e
over a long period of time with a minimum of maintenance.
Continuous satisfactory operation depends upon proper tool
care and regular cleaning.
WARNING: To reduce the risk of serious personal
injury, turn tool off and disconnect battery pack
before making any adjustments or removing/
installing attachments or accessories. An accidental
start-up can cause injury.
The charger and battery pack are not serviceable.
Lubrication
Your power tool requires no additional lubrication.
Cleaning
WARNING: Blow dirt and dust out of the main housing
with dry air as often as dirt is seen collecting in and around
the air vents. Wear approved eye protection and approved
dust mask when performing this procedure.
WARNING: Never use solvents or other harsh chemicals
for cleaning the non-metallic parts of the tool. These
chemicals may weaken the materials used in these parts.
Use a cloth dampened only with water and mild soap.
Never let any liquid get inside the tool; never immerse any
Speed Range
part of the tool into a liquid.
3–7
Optional Accessories
4–7
WARNING: Since accessories, other than those offered
2–7
by D
1–3
of such accessories with this tool could be hazardous.
To reduce the risk of injury, only D
accessories should be used with this product.
23
on a clean,
Consult your dealer for further information on the
appropriate accessories.
Protecting the Environment
17
.
be recovered or recycled reducing the demand for raw
materials. Please recycle electrical products and batteries
according to local provisions. Further information is available at
www.2helpU.com.
Rechargeable Battery Pack
This long life battery pack must be recharged when it fails to
produce sufficient power on jobs which were easily done before.
At the end of its technical life, discard it with due care for our
environment:
•
Run the battery pack down completely, then remove it from
the tool.
•
Li-Ion cells are recyclable. Take them to your dealer or a
local recycling station. The collected battery packs will be
recycled or disposed of properly.
WALT, have not been tested with this product, use
e
Separate collection. Products and batteries marked
with this symbol must not be disposed of with normal
household waste.
Products and batteries contain materials that can
EnGLIsh
WALT recommended
e
41
Publicidad
