Jimmy PW11 Pro Manual De Instrucciones página 8

Charging base assembly
Press charging base upper towards charging base lower
as the picture show. After a "click" sound is heard and
clips are located in corresponding holes, the assembly is
completed. (Fig 5)
Machine charging and placement
Place the floorhead in upright position, lift the machine,
align the charging slot at the rear of the machine with the
charging socket on the charging base, and gently place
down the machine into the charging base; To take out the
machine, hold the handheld vacuum handle and directly
pull the machine out of the charging base. (Fig 6)
Clean water tank assembly and
disassembly
To remove clean water tank, hold the clean water tank
handle and pull it upward to remove the clean water tank.
To install clean water tank, place it on floorhead and press
down until a "click" sound is heard. (Fig 7)
Brushroll assembly and disassembly
To remove the brushroll,remove clean water tank first, and
then press floorhead with one hand, rotate the brushroll
end cap upwards with another hand, and remove brushroll
outwards; When installing the brushroll, first align one
end of the brushroll with the spline, rotate it inward to the
bottom, and then rotate the brushroll end cap in another
end of brushroll to lock the brushroll. (Fig 8)
Chapter 2 Use of the Product
Note: Before use, please check whether the machine has power, if no power, please fully charge the machine
before using it.
LED screen and instructions
Lights indicater
Battery power
Dirty water
tank full indicator
Self cleaning
indicator
6
Cleaning
solution
housing
5
Clean water
tank handle
7
8
Air path blockage
indicator
Charging base
upper
Brushroll
housing
Charging base
6
lower
Mode display
Battery power icon
Brushroll drying indicator
Clean water tank
empty indicator
Auto water spray indicator
Spline