Publicidad
Idiomas disponibles
Idiomas disponibles
Use of stick vacuum and washer
In the upright tilt state, press the on/off button and product
start to work. Default mode is in Auto mode, press the
mode button to switch among floor mode, carpet mode
and Auto mode, accompanied by voice reminding. Press
the on/off button again, the voice reminds "Machine
turning off", the main motor will run for 2 seconds, the
machine stops working. (Fig 9)
In Auto mode, the machine power changes automatically
basing on how much dirty water or dust is detected. And
LED light colour changes accordingly. The more dirty
water or dust is detected, the more red lights. And the
less dirty water or dust is detected, the more blue lights.
Notes:
1. When cleaning carpet, please clean the floorhead
first (refer to "Cleaning and Maintenance, Floorhead
Cleaning" for details) and to deep clean carpet it is
recommended to replace the carpet brush. (Carpet brush
can be selected according to your own needs and sold at
JIMMY distributors)
2. When the battery level is lower than 20%, it cannot be
switched to Carpet mode.
When upright vacuum cleaner is working, press the water
spray button, the auto water spray function is open by
default. LED screen will show auto spray indicator and
clean water will be sprayed to brushroll automatically. To
turn off auto water spray function, keep pressing the self
cleaning button for over 3 seconds when product is on.
To turn on auto water spray function again, keep pressing
the self cleaning button for over 3 seconds when product
is on.(Fig 10)
If floor is very dirty, you can choose to spray more water to floor by using manual water spray function to
improve floor washing effect. With the machine turned on, press manual water spray button, spray mouth
sprays fan-shaped water; release the water spray button to stop spraying water. Manual water spray function
can be activated no matter whether auto water spray function is turned on or off. (Fig 11)
Note:
1. The manual water spray button cannot be used with the on/off button or the mode button at the same time.
2. It is recommended to use carpet mode when there is heavy pollution or water stain.
3. When cleaning carpet, please turn off auto water spray function.
4. Please use the low-foam cleaning solution with this product for cleaning, do not put the easy foaming
cleaning solution into the clean water tank for use, otherwise more foam will be generated during use, which
may penetrate into the machine and cause danger.
Product lay flat to vacuum function
When product is laid flat to clean under furniture, working power will automatically drop. This is normal. When
product is laid flat, do not shake the product violently to prevent water entering dust cup.
Use of handheld vacuum cleaner
1.Take off handheld vacuum cleaner and connect with accessories needed. Press on/off button. Display
screen will light up. Default mode is floor mode. Press mode button to switch between floor mode
and carpet mode. Press on/off button again to turn off the vacuum cleaner and display screen will
9
10
Manual Water
spray button
11
self-cleaning button
7
Publicidad
