Selector Locking Function (Z40 Model Or Z40 Service Model); Peel Counter Function - Zummo Z40 NATURE ADAPT Manual De Usuario

6.4. SELECTOR LOCKING FUNCTION
In order to lock the SELECT button to avoid unwanted changes of the number of fruits to
squeeze, carry out the following operations:
•
Select the number on the display you wish to lock.
•
Press the button ON and wait until the machine stops.
•
Switch off the machine using the power switch.
•
Being the machine switched off, press and hold STOP.
•
Switch on the power keeping STOP button pressed for four seconds. The display will
show a four digits' number.
•
Press the button SELECT (this button controls the two right digits) and press the button
ON (this button controls the two left digits) at the same time to select the number 7437.
Press STOP and the display will show - - - -. Turn off the machine using the power
switch. If you fail to do this, the display will keep showing the message - - - -
•
Switch on the machine. Now the SELECT button is locked and the display will show
Lock.
TO UNLOCK THE SELECT BUTTON.
Repeat exactly the same operation.

6.5. PEEL COUNTER FUNCTION

The machine has an automatic system for warning when the peel collection container is full. If
you want to activate this function, please proceed as follows:
• Turn off the machine's power switch.
• With the machine off, press SELECT, and continue pressing while turning the power
switch back on. Keep pressing for four seconds until you see the containers/chutes
appear on the display panel alongside a three-digit figure.
• Once this screen appears you need to enter the number of peels the machine needs to
produce before the alarm goes off. By pressing SELECT intermittently, the number of
peels will continue to increase. If, on the other hand, you press SELECT continuously for
more than two seconds, the number will start reducing.
• Once the number of peels has been selected, press STOP and that quantity will be held
in the machine's memory.
• Once the machine reaches the desired quantity it will stop and the two containers /chutes
on the display panel will blink. To continue juicing, the peel deposit must be emptied and
then the ON button pressed in order to reset the counter.
TO DEACTIVATE THE PEEL COUNTER.
Repeat the previous operation and set the counter to zero.
31