Sony PS-X50 Manual De Instrucciones página 3

NOTES ON INSTALLATION
@Place the turntable on a level surface.
e Avoid placing the unit near electrical appliances (such as a
television, hair dryer, or fluorescent lamp) which may cause hum
or noise.
@ Avoid any vibration such as from speakers, slamming of doors,
etc.
@ Keep the unit away from direct sunlight, extremes of tempera-
ture, or excessive dust and moisture.
eAllow 10 cm (4inches) clearance behind the unit so that the
cover can be opened.
E
+
N
N
E
E
o
LO
st
475 mm (183/44 in.)
eThe turntable has resilient feet that isolate the mechanism
from external shock and vibration. Use them in locked position,
but when placing the turntable on an uneven surface, turn each-
foot until the unit is level.
Resilient Foot
OPERATING VOLTAGE
Before connecting the unit to the power source, check that the
voltage selector setting is correct for your power supply. If the
selector must be reset, disconnect the ac power cord and set
the selector to the proper voltage using a screw driver.
(The voltage selector is located at the rear panel.)
The figure shows the voltage disposition
other than that of the UK model.
For the customers in the United Kingdom
WARNING: This apparatus must be earthed at the terminals in
your 3-pin plug as follows:
IMPORTANT: The wires in this mains lead are coloured in ac-
cordance with following code:
Green-and-yellow: Earth (safety earth)
Blue: Neutral
Brown: Live
As the colours of the wires in the mains lead of this apparatus
may not correspond with the coloured markings identifying the
terminals ii) your plug, proceed as follows:
The wire which is coloured green-and-yellow must be connected
to the terminal in the plug which is marked with the letter E or
by the earth symbol = or coloured green or green-and-yellow.
The wire which is coloured blue must be connected to the
terminal which is marked with the letter N or coloured black.
The wire which is coloured brown must be connected to the
terminal which is marked with the letter L or coloured red.