Publicidad
Idiomas disponibles
Idiomas disponibles
TURNTABLE
ASSEMBLY
CARTRIDGE
INSTALLATION
Do not connect
the power
cord or the
connecting
cords
until
For
the
customers
who
purchased
the
non-European
model:
after finishing the assembly.
Please skip this section and proceed with the following tonearm
Remove
all packing material
and clean the cabinet.
assembly
and adjustment.
A cartridge weighing up to 8.5 g can be mounted
with the sup-
plied shell.
Heavier cartridges from
8 to 16.5 g can
be mounted
using the
extra weight (supplied).
3
© Install the cartridge into the shell with the supplied mounting
screws
so that the distance between the shell end and the stylus
tip is approx.
49 mm
(1 15/16 inches).
The temporary overhang
adjustment
is then complete.
More precise adjustment
should
be made
later.
>
Fasten the screws lightly so
O
that the cartridge can slide
—
for adjustment.
Magnetic
coating
(inside the rim)
1
LL
approx. 49 mm
|
(115, .inches)
à Connect the lead wires of the shell to the corresponding
pins
on the cartridge.
Wires
Cartridge
pins
WihMtO:.casdssgns sas L (left channel signal)
BIUG
coco ici
da 50% LE or G (left channel
ground)
Redi. sos
4% R (right channel signal)
GREEN. sue
ss ee RE or G (right channel ground)
© Remove
the red-painted transit screws.
Save
these
screws,
since they will be required when
repacking.
O Carefully place the platter on the motor
board
by matching
the center hole and the center spindle.
eDo
not touch the magnetic coating with your fingers or damage
@A shell stand is provided on the base of the turntable for an
the magnetic
pick-up head.
extra mounted
cartridge.
© Place the rubber mat on the platter.
To remove
the dust cover
Open
the dust cover fully and slide it as illustrated while holding
it with both hands.
Publicidad
