Publicidad
Idiomas disponibles
Idiomas disponibles
TO REPLACE
THE S POOL:
1.Replace
the spool (1) w ith a new p re-wound
spool.
2.Insert the end o fline t hrough
the opening
(4) i n
the spool housing
(3).
3.Align the tabs on the s pool cover with t he slots in
the spool housing
on the trimmer
head.
4.Push down on the spool cover locking
ittothe
spool housing.
5. T o advance
the line w hen initially
installed,
you
must pull the line w hile pressing
the black line
release
button on the side ofthe spool housing
(3).
See R eplacement
Parts section
for p art number
and o rdering
information.
Replacement
Spool:
Model#
64212 available
ataSears and S ears.com
TO REFILL
THE S POOL:See
Figure 6, page ii.
1. Cut a length of .065" (1.65 ram) nylon
monofilament
line (1) approximately
18' (5.5 m)
long.
2. Insert end of line into the small hole (2) of an
empty spool to anchor the line.
3. Wind the line evenly and tightly in a clockwise
direction.
4. DO NOT wind the line beyond the edge (3) of the
spool.
5. Insert the line through hole (4) in the spool
housing.
6. Position line spool (5) in spool housing (6).
BAI-rERY
IMPORTANT!
The battery pack is not charged
when it is purchased.
Before using the trimmer for
the first time, place the battery pack in the battery
charger and charge. Make sure to read all safety
precautions,
and follow the instructions
in the the
Battery Charger section.
To removeSee
Figure 7, page ii.
1. Press the latch button (1) on the battery pack
down and hold.
2. Grasp the trimmer(2)
firmly, and pull the battery
pack out of the hadle.
Note: The battery pack fits into the handle snugly
in order to prevent accidental dislodging.
It may
require a strong pull to remove it.
To install
1. Align the tongue (3) of the battery pack with the
cavity in the string trimmer rear handle housing
2. Grasp the trimmer(2)
firmly.
3. Push the battery pack into the handle until the
latch locks into place.
4. Do not use force when inserting the battery pack.
It should slide into position and "click".
_1_ WARNING:
Follow these instructiong in order to avoid
injury and to reduce the risk of electric shock
or fire:
•
Replace the battery pack or the charger
immediately
if the battery case or charger
cord is damaged.
•
Verify that the switch is in the OFF position
before inserting
or removing
the battery
pack.
•
Verify that the battery pack is removed
and the switch
is in the OFF position
before inspecting, adjusting, or performing
maintenance
on any part of the trimmer.
•
Read, understand, and follow the
instructions
contained in the section
entitled Charging Procedure.
8 -- English
Publicidad
