SAFETY INSTRUCTIONS
WARNING
Only connect the device to an electrical connection which
has been set up by a qualified electrician as per
IEC 60364-1.
Only operate the device in wet rooms, e.g. bathroom,
connected to sockets with upstream residual current device.
Check the power supply cable with mains plug for damage
before operation each time. Do not put the device into
operation with a damaged power supply cable. Have a
damaged power supply cable replaced immediately by the
authorized customer service / qualified electrician.
Do not damage the power supply and extension cable by
running over it, crushing or yanking it or similar. Protect the
power supply cable from heat,
oil and sharp edges.
Unsuitable electrical extension cables can be dangerous.
Only use electrical extension cables with a splash guard and
a diameter of at least 3G1.5mm.
Only replace couplings on the power supply or extension
cable with those with the same splash guard and the same
72
mechanical strength.
Clean tiled walls with sockets carefully.
CAUTION
In case of longer breaks in operation and after use, switch
off the device at the main switch / device switch and pull the
mains plug.
OPERATION
DANGER
Operation in explosive atmospheres is prohibited.
When using the device in hazard zones (e.g. service
stations), adhere to the respective safety regulations.
Flammable or explosive liquid is prohibited to add in tank.
WARNING
Risk of scalding. Never touch the steam jet with your hand
from a close distance, and do not direct it at people or
animals.
Risk of scalding from high water output if you tilt the due
to more than 30° to the side when using it. (Applies to SC 1
devices only)
Risk of scalding on the hot steam boiler. Allow the steam
boiler to cool down before filling it with water.
Never disconnect accessories from the device while steam
is being expelled.
Hot water may drip out when disconnecting accessory parts.
Allow the device to cool down first.
During operation, never change the accessories for hot
water or steam. Allow the device to cool down first.
Replace a damaged hot water hose immediately with a hot
water hose as recommended by the manufacturer.
Do not steam any objects which contain harmful substances
(e.g. asbestos).
Do not add organic liquids or solvents.
EN
CAUTION
Only operate or store the device in accordance with the
description or figure.
Check the device and the accessories, in particular the
power supply cable and hot water hose, to make sure it
is in proper safe and reliable condition before operation
each time. Do not use the device if it is damaged. Replace
damaged components immediately.
Only switch on the device when water is present in the
water tank. The device may otherwise cannot start, see
chapter Troubleshooting.
Accidents or damage due to the device falling over. Before
all actions with or on the device, you must make sure that it
is stable.
ATTENTION
Do not fill with any cleaning agents or other supplements.
Do not operate the device at temperatures below 0 °C.
Never leave the device unsupervised while it is in operation.
73