Publicidad
Idiomas disponibles
Idiomas disponibles
2,3
1,2,3
1
2
3
[
[
C2Q0
QC2C2
Oom
090
CG35
QC2Q
OOCJ
moo
c1
- CLOCK
- SHIFT
Press
CLOCK
while
pressing
SHIFT
on the
remote control and press 1I SET within 4 seconds.
The hour flashes.
Press 44
DOWN or -
UP to designate
hour, then press II SET.
The hour stops flashing and the minute starts flashing.
Press +
DOWN or -
UP to designate
the
the
minute, then press 11 SET.
The minute stops flashing on the display and the clock starts
from 00 seconds.
To display the current time
Press CLO.CK while pressing SHIFT on the remote control. The
time is displayed for 4 seconds.
However, the time cannot be displayed during recording.
To switch
to the 24-hour standard
Press CLOCK while pressing SHIFT on the remote control and
then press
within 4 seconds.
Repeat the same procedure to restore the 12-hour standard.
~
This is caused by a power interruption. The current time needs
If power is interrupted for more than approximately 24 hours,
all settings stored in memory after purchase need to be reset.
1
1
2
The unit can be turned off automatically at a specified time.
Use the remote control.
1
2
Press SLEEP while pwessing SHIFT.
SLEEP
Within 4 seconds,
press -
or ~
to specify
the time until the power is turned off.
Each time the button is pressed, the time changes between 5
and 240 minutes in 5-minute steps.
m
Specified time
I
To check the time remaining until the power is turned off
Press SLEEP once while pressing SHIFT. The remaining time is
displayed for 4 seconds.
To
cancel the sleep timer
Press SLEEP twice while pressing SHIFT so that "SLEEP oFF
appears on the display.
ENGLISH
16
Publicidad
