Publicidad
Idiomas disponibles
Idiomas disponibles
Using the Wide Range Antenna (not supplied)
Use the wide range antenna AN-1 or AN-102 (not supplied).
There are following two methods.
Method A (For SW reception)
With a connecting cord, connect the OUTPUT jack of the antenna
controller (supplied with the AN-1 or AN-102) and the ACTIVE ANT
jack of the ICF-SW100.
Method B (For MW/LW reception only)
1 With the connecting cord, connect the OUTPUT jack of the antenna
controller and the INPUT jack of the antenna coupler (supplied with
the AN-1 or AN-102).
2 Put the antenna coupler near the ICF-SW100.
Example: When the AN-1 is used.
Antenna
coupler
(
to INPUT
HT>-3 oT] Antenna
to Lo °
3 controller
(MW/LW)
AN-1
to
ACTIVE ANT
(SW)
Notes
¢When using an external antenna, retract
eWhen receiving MW or LW broadcasts
the telescopic antenna.
without the active antenna, be sure to
Locate the outdoor antenna as far away
disconnect a SW external antenna.
from the street as possible.
Otherwise, you cannot receive them as
¢For details about the external antenna,
the built-in ferrite bar antenna does not
refer to its instruction manual.
function.
elf there is lightning, do not touch the
wire of an external antenna and
disconnect its AC power adaptor (if
connected) immediately. Never touch
the antenna wire during a lightning
storm.
Publicidad
