SETTING THE SPRAY GUN
4
SETTING THE SPRAY GUN
Determine the settings for the spray pattern, spray
i
jet width, amount of material, amount of air and
ascending feed pipe settings, see fig. 7 - 13 and the
description page 6/7.
SPRAY PATTERN SELECTION (FIG. 7)
A = vertical flat jet for horizontal surfaces
B = horizontal flat jet for vertical surfaces
C = Round jet for corners and edges and places difficult to access.
A
SETTING THE REQUIRED SPRAY PATTERN (FIG. 8)
Turn the air cap (1) to the required spray pattern position.
Never pull trigger while adjusting the air cap
settings.
Attention
6
B
C
1
SETTING THE SPRAY JET WIDTH (FIG. 9)
Adjusting ring
Turn to the right = wider spray jet
Turn to the left = narrower spray jet
The adjusting ring does not fasten the air cap!
i
SETTING THE AMOUNT OF MATERIAL (FIG. 10)
Set the amount of material by turning the material adjustment knob.
Turn to the left = more material
Turn to the right = less material
SETTING THE AMOUNT OF AIR (FIG. 11)
The correct setting for the amount of air is decisive for the atomization
and formation of paint mist.
Maximum
Minimum
Minimum
CAPSPRAY X 80