Descargar Imprimir esta página

Hatco Toast-Qwik TQ3-20 Serie Manual De Instalación Y Operación página 7

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 13
General
TQ3-20 Toast-Qwik
Conveyor Toasters are shipped fully
®
assembled. Care should be taken when unpacking the shipping
carton to avoid damage to the unit and the components
enclosed.
WARNING
ELECTRIC SHOCK HAZARD: Unit is not weatherproof.
Locate unit indoors where ambient air temperature is a
minimum of 21°C (70°F) and a maximum of 29°C (85°F).
EXPLOSION HAZARD: Do not store or use gasoline or
other flammable vapors or liquids in the vicinity of this or
any other appliance.
FIRE HAZARD:
• Allow a minimum clearance of 25 mm (1") along the
sides and rear of unit. Allow a minimum clearance of
305 mm (12") in the front, measured from chamber
opening on toaster body. If safe distances are not
maintained, discoloration or combustion could occur.
• Do not locate toaster under shelving or closer than
305 mm (12") from the ceiling.
• Do not place anything on top of toaster. Do not place
toaster near or underneath curtains or other combustible
materials. Items near or on top of toaster could catch fire
causing injury and/or damage to the toaster.
• In case of fire, disconnect toaster from power source
immediately. This allows unit to cool, making it easier
and safer to put out fire.
Locate unit at the proper counter height in an area that is
convenient for use. Location should be level and strong
enough to support weight of unit and contents.
NOTICE
Plug unit into a dedicated circuit. Do not use multiple
appliances on same circuit.
Do not locate unit in an area subject to temperatures above
29°C (85°F) or grease from grills, fryers, etc. Excessive
temperatures and grease could cause damage to unit.
Do not locate toaster in an area that restricts air flow
around front or rear of unit. Do not locate toaster in direct
discharge path of air conditioning vent or makeup air vent.
Damage to any countertop material caused by heat
generated from Hatco equipment is not covered under
the Hatco warranty. Contact manufacturer of countertop
material for application information.
TQ320CEM-0124
CAUTION
1. Remove the unit from the carton.
NOTE: To prevent delay in obtaining warranty coverage,
complete online warranty registration. See the
IMPORTANT OWNER INFORMATION section for
details.
2. Remove tape and protective packaging from all surfaces
of the unit.
3. Place the unit in the desired location.
• Locate the unit in an area where the ambient air
temperature is constant and between 21°C (70°F) and
29°C (85°F). Avoid areas that may be subject to active
air movements or currents (i.e., near exhaust fans/
hoods, air conditioning ducts, and exterior doors).
• Make sure the unit is at the proper counter height in an
area convenient for use.
• Make sure the countertop is level, made of non-
combustible material, and strong enough to support the
weight of the unit and its contents.
• Make sure all the feet on the bottom of the unit are
positioned securely on the countertop.
4. Install the toast slide rack, if necessary.
a. Slide the toast slide rack into the discharge chute opening.
b. Insert the toast slide rack pins into the pin slots on each
side of the discharge chute.
Installing the Toast Slide Rack
7
INSTALLATION

Publicidad

loading

Este manual también es adecuado para:

Toast-qwik tq3-20Toast-qwik tq3-20h