Publicidad
Idiomas disponibles
Idiomas disponibles
USES
The appliance is already arranged both for filte-
ring and for suction performances.
- In its filtering version (Fig. 1), the air and fu-
mes conveyed by the appliance are depured both
by a grease filter and by an active coal filter, and
put again into circulation through the hole made
on the top of the cabinet.
- In its sucking version (Fig. 2), fumes are di-
rectly conveyed outside, through an evacuation
duct connected with the superior part of the wall
or the ceiling. Both coal filter and air deflector are
not necessary in this case.
INSTALLATION
Before proceeding with the installation, to avoid
damaging the appliance, release the grease fil
ters.
The metal grease filters are removed by pushing
the filter towards the back side of the hood and
rotating it towards the low by unfasten it from its
seat (fig. 3).
For a correct assembly of the hood, in addition to
the filters, remove the grease bowl by acting on
the knobs as indicated in draw. 4, so as to loosen
the socket and then pull the bowl downwards (fig.
5).
Essential precautions to respect before installing
the appliance are the following:
To have made a cut-out on the bottom of the ca
binet which is suitable to hold the appliance in
position (fig. 6).
- Prepare the power supply.
- Prepare a hole for the exhaust of the air both in
the filtering and in the exhauting version.
To install the appliance, adjust the position of the
stop side-springs using the appropriate screws
(fig. 7), according to the thickness of the board
previously drilled, on which the appliance will be
fixed.
Insert the built-in unit in the hole made in the cabi
net until the stop click of the side- springs is heard
and the built-in unit is blocked.Insert the screws
provided in the holes inside the appliance (fig. 8)
to block it completely.
Restore the filters and the grease bowl in the ini-
tial position.
Blocking of the stop valve.
Warning!
Before connecting the flexible exhausting pipe to
the motor, make sure the stop valve, which is on
the air outlet of the motor, can swing.
Exausting version
Connect the flange to the exhausting hole with an
appropriate pipe. Connect the appliance with the
electrical mains through the supply cord.
Filtering version
Connect the flange with a pipe suitable to con
vey the air to the top of the cabinet. Connect the
appliance with the electrical mains through the
supply cord.
13
Publicidad
