Craftsman professional 152.229020 Manual De Instrucciones página 13

TOOLS REQUIRED
The following toob are needed for assemMy and align-
ment, Note: Hex wrenches are provided, The remaining
toob are typbaU shop tooUsand are not included with
your ddH press,
12mm Open end wrench 13mm Open end wrench
#2 PhHHpsscrewdriver Hammer and Mock of wood
* The drHU press is a heavy machine; two peopb may
be required for certain assemMy operations,
* DO NOT assembb the ddH press until you are sure
the tooUis unpUugged,
* DO NOT assembb the ddH press until you are sure
the power switch is in the "OFF" position,
* For your own safety, DO NOT connect the drHU press
to the power source untiUthe machine is completely
assembled and you read and understand the entire
Instruction Manual,
COLUMN, BASE and TABLE ASSEMBLY
Figure 4-1
i i
I
I
C
1, Attach the column (A) to the base (B) using
the four M8x1,25 x 25mm hex head screws (C),
See Figure 4-1,
2, Loosen the set screw (D) and remove the ring (E)
and rack (F),
Figure 4-2
3, Place the worm gear (G) in the table bracket (H),
See Figure 4-2,
Figure 4-3
K
NOTE: Place the small end of the worm gear (I)
through hob (J), in the table bracket, See Figure 4-2
and 4-3,
4, insert the rack (F) in the table bracket groove (K),
See Figure 4-3,
13