Craftsman professional 152.229020 Manual De Instrucciones página 15

DRILL PRESS HEAD AND Figure 5-3
MOTOR ASSEMBLY
The ddH press is a heavy machine; two peopb may
be required for certain assemMy operations,
MAKE CERTAIN the ddH press is disconnected from
the power source,
Figure 5-1
A
1, Seat the ddH press head (A) on the coUumn (B),
See Figure 5-1,
Figure 5-2
C
2, Align the drill press head with the table (C) and
base and tighten the two head locking screws (D),
See Figure 5-2,
E
F
E
3, Thread the three feed handles (E) in the three
tapped hobs located in the pinion shaft (F),
Figure 5-4
IG
15
NOTE: Make certain that the chuck arbor taper (G) and
the tapered hob in the chuck (H) are clean and free of
grease, lacquer, or rust preventive coatings, See
Figure 5-4_ Household oven cleaner can effectively
remove any substance from the spindle and chuck,
Carefully follow the manufacturer's safety rubs con-
cerning its use,
4,
Open the chuck jaws completely, hold the top collar
(I) and turn the chuck barrel (J) clockwise, Make
sure the jaws are completely recessed inside the
chuck, See figure 5-4,