Craftsman professional 152.229020 Manual De Instrucciones página 14

Figure 4-4 Figure 4-6
L
The drill press is a heavy machine; two people may be
required for certain assembly operations,
5, Slide the rack (F) and the table (L) onto the column
(A), See Figure 4-4,
Figure 4-5
O
P
N
7,
8,
Attach the knob (N) to the table raising and lower-
ing handle (O), See Figure 4-6,
Attach the table raising and lowering handle on the
worm gear shaft (I) and tighten the set screw (P)
against the fiat (R) on the worm gear shaft,
Figure 4-7
S
6, Place the ring (E) onto the column (A),
See Figure 4-5,
NOTE: Hace the rack under the bottom of the ring, but
allow enough clearance so that the rack can rotate
around the column, Tighten the set screw (M), See
Figure 4-5,
9,
14
Thread the table lock handle (S) into the hole (W) in
the rear of the table bracket, See Figure 4-7,