RS Pro RS-8852 Manual De Instrucciones página 4

Sound level meter with datalogger / English
REC button
DATALOGGER function
Press "REC" button after it power on, the display will show "REC" to start Data Recording, press the
button again to exit the record (Note: In order to avoid data error, please don't power it off under REC
condition, when the REC function is deleted then it can power off).
Adjusting DATALOGGER response
Press the button continuously before power it on, then press , it will be displayed as following: Press
'LEVEL' button to adjust memory time,press 'HOLD' button to hold the setup
Data zero function
Press the button continuously before power it on, loosen the button when the display
showing'CLR' after the meter power on,which indicates that the data in DATALOGGER
has been deleted.
SETUP button
The time chip adjustment
Press'SETUP'button and then power it on, when'TIME'symbol displays then
loosen'SETUP', the meter will be under time adjustment mode, at the time the display will
show the date as following:
Press the'SETUP'button second time, the display showing:
The display showing "minute" adjustment mode, press 'LEVEL' to make the adjustment,
press 'HOLD' to keep the setup,
Press the'SETUP'button third time, the display showing:
The display showing "hour" adjustment mode, press (h-P=P.M,h-A=A.M) 'LEVEL' to make
the adjustment, press'HOLD'to keep the setup
Press the'SETUP'button fourth time, the display showing:
The display showing "date" adjustment mode, press 'LEVEL' to make the adjustment,
press'HOLD'to keep the setup
Press the 'SETUP'button fifth time, the display showing:
4
The display showing "month" adjustment mode, press 'LEVEL' to make the adjustment,
press 'HOLD' to keep the setup
Press the 'SETUP' button sixth time, the display showing:
The display showing "year" adjustment mode, press 'LEVEL' to make the adjustment,
press 'HOLD'to keep the setup
Press the 'SETUP' button seventh time, the display showing:
The display showing initialization of the time chip, press 'HOLD' to keep the setup; time and date have
returned to factory setup. When the battery is exhausted or replaced, if the time can't be adjusted then
please initialize the time chip first.
4.1. USB communications setting:
Turn on the meter, connect the meter with the computer correctly, choose the software COM3 (COM4), hen
press 'ETUP' , ' ' disappears from the display to indicate and disable auto power off, that the USB data is
transmitting.
FAST/SLOW button:
Time weighting selection
FAST: st sampling measurement, 1 time per 125mS.
SLOW:Slow sampling measurement, 1 time per second.
MAX/MIN button:
Maximum and Minimum hold Press this button for one time to enter MAX/MIN measurement, 'MAX' will
appear on LCD, maximum sound level will be captured and held until higher sound level is captured. Press
the button again, 'MIN' will appear on LCD and minimum sound level will be captured and held until new
lower sound level is captured. Press the button one more time to exit MAX/MIN measurement.
LEVEL button: Level range selection
Each time you press "LEVEL" button, the level range will change between 'Lo' level, 'Med' level, 'Hi' level
and 'Auto' level in the circular.
Backlight button
• Turn the backlight on/off
• DATALOGGER response setting;
press the button continuously until'INT'symbol appears after the meter turn on,
press'LEVEL'to set up the data memory response, then press'HOLD'to keep the
setting.
Sound level meter with datalogger / English
5