RS Pro RS-979E Manual De Instrucciones página 4

Thermal Imager / English
Data communication interfaces
Interfaces USB-Type C
USB Data transform between camera and PC
Live video between camera and PC
Wifi 802.11, transfer images and realtime video stream.
Power system
Battery Li-ion battery, 4 hours operating time
Input voltage DC 5V
Charging system In camera (AC adapter)
Power management Automatic shutdown
Environmental data
Operating temperature range -15°C to +50°C (5°F to +122°F)
Storage temperature range –40°C to +70°C (–40°F to +158°F)
Humidity (operating and storage) 10%~90%
Drop test 2m
Bump 25g(IEC60068-2-29)
Vibration 2g(IEC60068-2-6)
Physical data
Camera weight, incl. battery <500g
Camera size (L × W × H) 224x77x96
5. Before You Start
5-1. How to Charge the Battery
Before you use the Thermal Imager for the first time, charge the battery for three and three-half hours. The battery status
shows on the six-segment charge indicator.
To charge the battery, use follow before:
1. Connect the ac power adapter into an ac wall outlet and connect the dc output to the Thermal Imager's ac power
socket, the charge light is on. The battery indicator becomes "
battery charges with the ac power adapter.
2. Charge until the charge indicator becomes , the charge icon not changed .
3. Disconnect ac power adapter when the battery is full charged.
Note: Make sure that the Thermal Imager is near room temperature before you connect it to the charger. Do not charge in
hot or cold areas. When you charge in extreme temperature, battery capacity may be decreased.
6
5-2. Power On
To turn the Thermal Imager on, push the Power Button.
Note: After power on the device, The thermal Imager needs sufficient warm-up time for the most accurate temperature
measurements and best image quality. So the visible image will first appear, and the thermal sensor will calibrate internal
for sevearal seconds. After that the thermal image will be displayed on the screen.
", while the
5-3. Power Off
When Thermal Imagers power on, Push and hold the Power
seconds, then popup the power off menu, press "OK" to power off the device.
Push and hold the Power
forced power off directly.
Button for two
Button for twelve seconds, the device will be
Thermal Imager / English
7