Descargar Imprimir esta página

Miniland digimonitor 2.4' Manual Del Usuario página 15

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 1
PROBLEM
No reception on the monitor.
Only black and white images are
displayed.
The camera does not transmit.
You cannot hear the baby on the
parent unit.
Interference or poor reception.
You cannot charge the battery in the
parent unit.
If the Baby Unit has lost its link with
the Parent Unit.
8. TECHNICAL SPECIFICATIONS
Frequency
Operating Range
Nº of configurable channels
Power (parent unit)
Rechargeable battery for monitor
Power (baby unit)
Operating time with battery fully charged (parent unit)
LCD Screen size
9. PRODUCT DISPOSAL INFORMATION
· Remember to dispose of the product responsibly.
· Do not mix products bearing the crossed -out bin symbol with your
general household waste.
· For the correct collection and treatment of these products take them to
the collection points designated by your local authority.
Alternatively contact the retailer who sold you the product.
POSSIBLE CAUSE
Connection lost between the monitor and a
camera already linked.
A wrong camera has been selected.
Check whether the camera is in night vision/
infrared mode.
The camera is not turned on.
Camera: the power adapter is not plugged in.
VOX mode or Standby mode are active.
The volume setting of the parent unit is too low.
Other electronic devices may be interfering
with the signal.
The camera and monitor may be too far apart.
The battery power may be too low.
The camera or monitor may be placed too
close to many metal objects.
The AC/DC adapter is not plugged in.
The camera and monitor may be too far apart.
The link between both units has been lost
momentarily.
The link between bothunits has been lost.
SOLUTION
Link the camera with the monitor again. See 5.2.9.2.1.
Change the camera number you are watching. See 5.2.9.2.3.
In order to view the images in colour, increase the level
of light in the room the camera is in or check there is
nothing covering the camera´s light sensor (I).
Plug in the power adapter.
Plug in the power adapter.
To see the monitored area continuously, disconnect the
VOX or Standby mode on the Monitor.
Set the volumen to the highest level.
Move them away from the device.
Move the monitor closer to the camera.
Plug in the power adapter.
Move them away from the device.
Plug in the adapter.
Move the monitor closer to the camera.
Reset the units by disconnecting them from the
electrical power. Wait about 15 seconds before
reconnecting. Allow up to one minute for the Baby Unit
and the Parent Unit to synchronize.
Pair the camera and monitor again. See 5.2.9.2.1.
2.4GHz FHSS
200-250m (straight line and open space)
4
Input: 100-240VAC 50/60Hz
Output: 5V 1 A
3.7V 900 mAh
Input: 100-240 VCA 50/60Hz
Output: 5V 1 A
Approximately 5 hours
2.31''
Hereby, Miniland S.A. declares that this "89591
digimonitor 2.4''" is in compliance with the
essential requirements and other relevant
provisions of Directive 2014/53/UE.
15
ENGLISH

Publicidad

loading

Este manual también es adecuado para:

89591