NEXPEAK NC202 Guia Del Usuario página 4

How To Use
STEP1
Connect the charger with the battery
12V/24V
(red positive and black negative)
STEP2
Connect the charger with the outlet, AC input voltage from
100-240 volt.
STEP3
Press button to choose the corresponding charging mode.
Charging Mode Explanation
NEXPEAK NC202 battery charger has four(4) modes: CAR, AGM/LiFePO4, MOTO
and REPAIR. Pressed the "
These modes are advanced charging modes that require your full attention before
selecting. It is important to understand the differences and purposes of each mode.
Always check with the battery manufacturer to confirm the right charging mode for your
specific battery. Do not operate the charger until you confirm the appropriate mode for
your battery. Below is a brief introduction:
Mode Explanation
Suitable for charging ordinary batteries(car boat ...) including GEL, SLA, WET,
DEEP CYCLE, EFB, etc.
CAR/BOAT
Suitable for charging AGM and LiFePO4 batteries.
AGM/LiFePO4
Suitable for all kinds of motorcycles and small capacity(>2AH) lead-acid
batteries.
MOTORCYCLE
For battery maintenance, increase the battery health status or activate the
battery. 0V or bad cells batteries are forbidden to use.
REPAIR
" button to switch the charging mode.
EN - 3