Igloo ICF 18 Instrucciones De Uso página 19

ICF18, ICF32, ICF40, ICF60, ICF80DZ
1. Place the cooler on a firm foundation.
Make sure that the ventilation slots are not covered and that the heated
air can dissipate. We recommend keeping a gap of at least 50 mm around
ventilation holes.
A
NOTICE! Damage hazard
Place the cooler as shown (fig. 1, page 3). If you operate the
cooler in a different orientation it can be damaged.
2. Connect the cooler (see chapter "Connecting the cooler" on page 16).
A
NOTICE! Excessively low temperature hazard
Ensure that the only those objects are placed in the cooler that are
intended to be cooled at the selected temperature.
3. Press the "ON/OFF" button (fig. 3 1, page 5) for between one and two
seconds.
✔ The LED "P" lights up (fig. 3 2, page 5).
✔ The display (fig. 3 4, page 5) switches on and shows the current temper-
ature.
✔ The cooler starts cooling the interior.
I
NOTE
When operating from a battery, the display switches off automati-
cally if the battery voltage is low. The LED "P" flashes orange.
6.6 Setting the temperature
ICF18,ICF32, ICF40, ICF60:
1. Press the "SET" button (fig. 3 5, page 5) once.
2. Use the "UP +" (fig. 3 7, page 5) and "DOWN –" (fig. 3 6, page 5) but-
tons to select the cooling temperature.
✔ The cooling temperature appears in the display for a few seconds. The dis-
play flashes several times and then the current temperature is displayed
again.
EN
Operation
19