Publicidad
Idiomas disponibles
Idiomas disponibles
COMMERCIAL COFFEE GRINDER
Opera on
INFORMATION!
Risk of damage!
The operator has no infl uence on the thermal overcurrent circuit-
breaker. If the thermal overcurrent circuit-breaker has been triggered
several mes, a service partner must be contacted for advice as the
motor winding can become damaged.
• The grinder has a thermal overcurrent circuit-breaker which
interrupts the electric circuit of the grinder in case of electrical
overload.
To put the grinder into opera on again, fi rst set the on/off
switch (3) to switch posi on 0 (off ) and disconnect the power
plug (13).
Then press the release bu on (4).
You can now plug the power plug back into the socket and
put the grinder into opera on (see chapter "Se ng up the
grinder").
• The grinder also has a motor protector, which switches off
the grinder when the motor becomes too hot. As soon as the
motor has cooled down, the grinder can be put into opera on
again (see chapter: "Troubleshoo ng").
Connec ng the grinder and se ng the grinding degree
• The grinding degree scale of the grinding degree adjustor (2)
displays the desired grinding degree.
The fi nest se ng is "1".
• Reduce the grinding degree only while the grinder is in opera on.
1. Make sure that you have inserted the power plug (13) into a properly
installed safety socket.
2. Turn the grinding degree adjustor (2) towards "1" for fi ne coff ee grinding
and in the opposite direc on for coarse coff ee grinding (see Fig. C).
32
Publicidad
