Descargar Imprimir esta página

YATO YT-55801 Manual Original página 11

Máquina de limpieza ultrasonidos para taller

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 54
PRODUCT OVERVIEW
The ultrasonic workshop cleaner is suitable for removing dirt from various types of components and for cleaning tools. Ultrasonic
cleaning enables eff ective cleaning, degreasing, even in hard-to-reach areas, without having to take components apart or small
parts. Proper, reliable and safe operation of the product requires its correct use, that is why you should:
Read the entire instructions manual before the fi rst use of the product and keep it for future reference.
The supplier shall not be held liable for any damage or injury resulting from improper use of the product, failure to observe the
safety regulations and recommendations of this instructions manual. Use of the product for purposes other than those for which it
was intended shall cause the loss of the user's rights to the warranty and under statutory warranty.
COMPONENTS
The product is supplied complete and does not require assembly. Preparations described later in this manual are also required.
Parameter
Part No.
Rated voltage
Rated frequency
Rated power
Insulation class
Protection rating
Size of basket (L x W x H)
Machine dimension (L, x W x H)
Operating temperature
Ultrasound frequency
Operation time
fl uid tank capacity
Drain valve thread size
Net weight
SAFETY INSTRUCTIONS
Recommendations concerning transport and installation of the product
NOTE! The product may only be placed on a hard, fl at, level, and non-fl ammable surface.
The surface should be able to withstand the weight of the appliance itself and of the parts
and fl uid it contains. Ensure that there is a minimum distance of 10 cm around the side walls
of the product, and do not place non-high temperature resistant materials above the product.
This will allow for the proper ventilation of the product. Do not place near edges of, e.g., a
table. Do not place any electrical equipment above the product. During operation, water va-
pour is released, which can cause a short circuit in the electrical system and lead to electric
shock. It is forbidden to drill any holes in the product, as well as making any other modifi ca-
tions of the product not described in the manual. Move the product only when cooled down,
grasping the housing. Do not move the product by pulling the power cord. No metal objects
or surfaces should be placed on or near the back of the product. Do not place the product in
high temperature areas. The temperature at the place of installation and use of the product
must be within the range of +10°C ÷ +38°C, and the relative humidity must be below 90%
without water vapour condensation.
O R I G I N A L
EN
Unit
[V~]
[Hz]
[W]
[mm]
500 x 300 x 150
[mm]
500 x 325 x 285
[°C]
[kHz]
[min]
[l]
[kg]
I N S T R U C T I O N S
Value
YT-55801
220-240
50/60
480
I
IPX0
0 ~ +80
40
0-30
22
G1/2
9.5
YT-55803
220-240
50/60
600
I
IPX0
500 x 300 x 200
500 x 325 x 325
0 ~ +80
40
0-30
30
G1/2
11
11

Publicidad

loading

Este manual también es adecuado para:

Yt-55803