Publicidad
Idiomas disponibles
Idiomas disponibles
STEP 1
REMOVING OLD TOILET
Turn o the water supply. Flush the toilet to empty the tank. Remove any water left in the tank or bowl.
Disconnect the supply line from the tank. Remove decorative caps. Unscrew nuts that attach the toilet to the floor.
Remove toilet.
STEP 2
INSTALLATION PROCEDURE
Make sure the water supply valve is shut o before installation. Remove old floor bolts from floor flange. Clean any
old wax, putty, etc. from base area.
Install new floor bolts (N) into floor flange. Use plastic retaining washers (O) to hold bolts in full length, upright
position. You can pre-cut the floor bolts to the desired length to put on the bolt cap by doing the following:
Temporarily install floor bolts and set the toilet and place the washers and nuts onto the bolts. Then mark the length
needed. Take toilet out of the place and remove the floor bolts. Cut the floor bolts to the desired length.
STEP 3
INSTALLATION PROCEDURE
Turn toilet bowl upside down onto a soft surface. Place a new wax ring (M) around the raised outlet ring of the bowl
with the rounded (tapered) end of the ring facing the toilet, and press firmly enough so the wax ring adheres to the
bowl. (Figure 1)
Lower the toilet onto the floor bolts (N), so the bolts protrude through mounting holes in base of toilet. (Figure 2)
Using a rocking motion, press the bowl down to position the toilet onto the flange.
© 2024 FGI Industries, Ltd. | CRAFT + MAIN®, DEVEN™, FLUSH GUARD™, and logo designs are trademarks or registered trademarks of FGI Industries, Ltd.
USA: www.flushguardtoilets.com / www.craftandmain.com | CANADA: www.craftandmain.ca
JANUARY 18, 2024
INSTALLATION AND USER GUIDE
DEVEN™ Complete 2-Piece Toilet
TL-5800BFH-EW / TL-5800BFH-RW
O
Figure 1
M
N
Floor
Flange
Figure 2
N
3
Publicidad
