Publicidad
Idiomas disponibles
Idiomas disponibles
STEP 8
CONNECTING WATER SUPPLY
Connect water supply line (new or existing) between shuto valve and tank inlet water fitting. Tighten coupling nuts
securely.
NOTE: DO NOT OVERTIGHTEN.
Turn on supply valve and allow tank to fill until float rises to shuto position.
Check for leakage at fittings, tighten or correct as needed.
STEP 9
PRIMING THE FLUSH GUARD OVERFLOW PROTECTION FEATURE
This toilet is equipped with the FLUSH GUARD™ Overflow Protection feature. This is a separate water channel
built-into the toilet that allows water to drain even when the main trapway is clogged.
This separate overflow water channel incorporates a small P-trap to prevent sewer gases from entering the house.
This P-trap is rinsed and refilled every time you flush.
When the toilet is first installed, it should be flushed twice to make sure the P-trap in the overflow water channel is
completely filled with water.
!
TROUBLESHOOTING
Problem: Poor Flush, the water level is below water line mark.
Solution: Fine tune the fill valve adjustment rod to increase or decrease the water level in the tank.
Problem: Continuous water running.
Solution: It may occur if the flush seal is not completely closed. Verify if there is any obstruction with the flush seal
and that the seal is in contact with the valve lip.
REPAIR PARTS:
Fill Valve w/Float
Flush Valve w/Flapper
Large Rubber Gasket
Tank Lever
Toilet Seat
Wipe the outside of the toilet gently with a damp cloth and blot dry with a soft towel. Make sure that the complete surface is
cleaned and completely dry. NOTE: IMPROPER CARE MAY CAUSE THE WARRANTY TO BECOME INVALID.
© 2024 FGI Industries, Ltd. | CRAFT + MAIN®, DEVEN™, FLUSH GUARD™, and logo designs are trademarks or registered trademarks of FGI Industries, Ltd.
USA: www.flushguardtoilets.com / www.craftandmain.com | CANADA: www.craftandmain.ca
JANUARY 18, 2024
INSTALLATION AND USER GUIDE
DEVEN™ Complete 2-Piece Toilet
TL-5800BFH-EW / TL-5800BFH-RW
6
Publicidad
