Publicidad
Idiomas disponibles
Idiomas disponibles
STEP 4
INSTALLATION PROCEDURE
Install plastic cap washers (K), followed by metal washers (P) and nuts (Q) onto the floor-bolts (N). Tighten the
bolts alternately until toilet is firmly seated on the floor. Install the plastic bolt caps (K).
CAUTION: DO NOT OVERTIGHTEN NUTS, SEVERE DAMAGE MAY OCCUR.
STEP 5
INSTALLING THE TANK
Place a metal washer (E) followed by a rubber washer (D) onto each
bolt (F). Insert the bolts (F) with washers (E & D) through the holes
inside the tank.
Place a metal washer (E) followed by a metal nut (G) onto each bolt
(F) protruding from the bottom of the tank. Tighten the metal nuts
(G) to create a proper and secure seal.
Attach the rubber sealing gasket (J) to the center drain hole under
the tank. Gently place the tank on the toilet bowl with the bolts (F)
protruding out through the holes in the bowl.
Place an oval metal washer (H) followed by a wing nut (I) onto each
of the protruding bolts (F). Tighten the wing nuts (I) enough so that
the tank sits flat on the toilet bowl.
Make sure the tank is parallel to the wall and straight on the toilet
bowl.
CAUTION: DO NOT OVERTIGHTEN NUTS. SEVERE DAMAGE
MAY OCCUR.
© 2024 FGI Industries, Ltd. | CRAFT + MAIN®, DEVEN™, FLUSH GUARD™, and logo designs are trademarks or registered trademarks of FGI Industries, Ltd.
USA: www.flushguardtoilets.com / www.craftandmain.com | CANADA: www.craftandmain.ca
JANUARY 18, 2024
INSTALLATION AND USER GUIDE
DEVEN™ Complete 2-Piece Toilet
TL-5800BFH-EW / TL-5800BFH-RW
Q
P
K
N
4
K
E
D
F
J
G
H
I
Publicidad
