Publicidad
Idiomas disponibles
Idiomas disponibles
Attaching the
Fan Blades
NOTE: Your fan features revolutionary advance-
ments for quick and easy blade installation.
NOTE: Your fan blades are reversible. Select
the blade side finish which best accentuates
your decor
1. Fasten the blade arm to the motor by insert-
ing the alignment post into the slot on the
bottom of the motor and tightening the mo-
tor screws. Please note that the motor screws
are pre-attached into the blade bracket (Figure
14). Repeat for the remaining 4 blade arms.
2. Mount the fan blades to the blade arms by
aligning the three key-slot holes in the blade
with the three posts on the top of the blade
arm (Figure 15).
3. Hold the blade with both hands close to the
blade arm and press the blade down firmly.
Ensure the key-slot holes are properly seated
on the blade arm posts.
4. While still holding the blade down with both
hands, firmly slide the blade away from the
motor housing until the blade engages in
the locking mechanism. Make sure the steel
locking mechanism at the rear of the blade
arm springs upward and butts against the
edge of the blade indicating a secure con-
nection.
8.
5. Visually inspect the top of the blade arm to
ensure that the locking mechanism is secure-
ly in place.
6. Repeat for the remaining blades.
Attaching the Light Kit
REMEMBER to disconnect the power.
1. Remove the three mounting screws on the
black bracket below the motor (Figure 16).
2. Connect the wires exiting the bottom of the
motor with the light kit by connecting the
molded adaptor plugs together (Figure 16).
3. Slide the switch cup light kit and secure it to
the black bracket using the three screws that
were removed in step 1 (Figure 16).
Figure 14
Figure 15
Figure 16
Publicidad
