HAMPTON BAY Lyndhurst Manual Del Propietário página 7

"Close-to-Ceiling"
Mounting
1. Remove the canopy ring from the canopy by
turning the ring to the right until it unlocks
(Figure 5).
2. Remove the mounting bracket from the can-
opy by loosening the four screws on the top
of the canopy. Remove the two non-slotted
screws and loosen the slotted screws. This
will enable you to remove the mounting
bracket (Figure 6).
3. Remove the decorative canopy bottom cov-
er from the canopy by depressing the three
studs (Figure 9).
4. Remove three of the six screws and lock-
washers (every other one) securing the mo-
Figure 8
tor collar to the top of the fan motor housing.
(Figure 10).
5. Place the rubber gasket over the remaining
three screws, route the wires exiting the
top of the fan motor through the canopy
Figure 9
ring (make sure the slot openings are on
top), then proceed to place the ceiling can-
opy over the collar at the top of the motor
(Figure 11).
6. Tighten the mounting screws securely.
FAILURE TO COMPLETELY TIGHTEN THE
THREE SCREWS IN STEP 6 COULD RESULT IN
FAN LOOSENING AND POSSIBLY FALLING.
Figure 10
Figure 11
5.