Kohler K-7202 Guia De Instalacion página 3

Plug
Control Knob
Waste Flange
Waste Seal
Waste Body
Coupling Nut
Compression Ring
Compression Seals
Compression Ring
Coupling Nut
Tailpiece
1. Initial Assembly
NOTE: When installing this drain on bath models K-1110-M and
K-1110-V, 2-1/4" (5.7 cm) must be removed from the overflow pipe.
Remove the overflow body, waste body, tailpiece and tee from the
packaging.
Remove the coupling nuts, compression rings and compression
seals from the tee.
Slide a coupling nut, compression ring and compression seal on
the overflow pipe. Repeat this process on the waste pipe and
tailpiece.
Fit the overflow, tailpiece and waste pipes into the tee.
Hand tighten the coupling nuts onto the tee allowing movement
of both the overflow and waste bodies.
Do not fully tighten at this time.
Kohler Co.
Overflow Ferrule
Back Plate
Overflow Seal
Waste Pipe
Overflow Body
Tee
Overflow Pipe
Coupling Nut
Compression Ring
Compression Seal
3
Hex Wrench
Spanner
1013265-2-D