Craftsman 917.28955 Manual Del Operador página 15

The operation of any tractor can result in foreign objects thrown into the
eyes, which can result in severe eye damage° Always wear safety glasses
or eye shields while operating your tractor or performing any adjustments
or repairs. We recommend standard safety glasses or a wide vision safety
mask worn over spectacles.
HOW TO USE YOUR TRACTOR
TO SET PARKING BRAKE
"Yourtractor is equipped with an operator
presence sensing switch. When engine is
running, any attempt by the operator to leave
theseat withoutfirst setting the parking brake
will shut off the engine.
1. Depress clutch/brake pedal (B) all the
way down and hold.
2. Pull parking brake lever (C) up and hold,
release pressure from brake pedal (B),
then release parking brake lever. Pedal
should remain in brake position. Make
sure parkingbrake willholdtractorsecure.
NOTE: Failure to move throttle control be-
tween half and full speed (fast) position, be-
fore stopping, may cause engine to "backfire".
- Turn ignition key (F) to "STOP" position
and remove key. Always remove keywhen
leaving tractorto prevent unauthorized use.
• Never use choke (N) to stop engine.
IMPORTANT; Leaving the ignition switch in
any position other than "STOP" will cause
the batter,/to discharge and go dead.
NOTE; Under certain conditions when tractor
is standing idle with the engine running, hot
engine exhaust gases may cause "brown-
ing" of grass. To eliminate this possibility,
always stop engine when stopping tractor
on grass areas,
_CAUTION: Always stop tractor com-
pletely, as described above, and set parking
brake before leaving the operator's position.
STOPPING
MOWER BLADES
o To stop mower blades, push attachment
clutch switch in to disengaged position (O)_
(I) Attachment
Clutch Switch
Pull Out To "Engage"
(O) Push-ln to
"Disengaged"
GROUND DRIVE -
• To stop ground drive, depress clutch/brake
pedal all the way down.
• Move gearshift lever (J) to neutral position.
ENGINE -
° Move throttle control (D) between half and
fu!l speed (fast) position.
TO USE THROTTLE CONTROL (D)
Always operate engine at full speed (fast).
, Operating engine at less than full speed
(fast) reduces engine's operating ef o
ficiency.
• Full speed (fast) offers the best mower
performance.
TO USE CHOKE CONTROL (N)
Use choke control whenever you are starting
a cold engine. Do not use to start a warm
engine.
o To engage choke control, pull knob out.
Slowly push knob in to disengage_
15