Publicidad
is a registered trademark of Northern Sports Insight and Intelligence Oy in EU and USA.
2024 Northern Sports Insight and Intelligence Oy. All Rights Reserved.
DISCLAIMER
We do not guarantee that ACT Head Impact Tracker products or services will meet your requirements. We do not guarantee that ACT Head Impact Tracker
mobile application, head sensor hardware or firmware,
cloud service or firmware, data transfer
or
any other part of the products or services, any information
obtained from using the products or services will be safe, error-free, secure or timely. We do not guarantee that information received or not received when
using ACT Head Impact Tracker is accurate or reliable, or that the errors in the products or services are corrected. We cannot guarantee that ACT Head Impact
Tracker products or services, or any content therein, will always be available or uninterrupted.
DESIGNER AND MANUFACTURER
Northern Sports Insight and Intelligence Oy
Address: Northern Sports Insight and Intelligence Oy, Terkko Health Hub, Haartmaninkatu 4, Building 14, 00290 Helsinki, Finland
Email: contact@norspo.com
GENERAL INFORMATION
User Manual for ACT Head Impact Tracker head sensor (latest firmware version 0.72). This manual was last updated the 2
of April, 2024.
nd
We may occasionally issue updates to this document. Please check www.act-tracker.com for updated and latest information. Please see Help FAQ for use,
operation, management and troubleshooting at www.act-tracker.com
ILLUSTRATED INSTRUCTIONS
Adding hook and loop -tape to the sensor
Place the sensor on the table head-side down and back side up. The glue tape area on the sensor is covered by a yellow cover foil (1.). If you want to use hook
and loop tape to attach the head sensor, take one piece of hook tape, remove the yellow cover foil from the sensor's glue area and cover foil of hook tape
piece. Add the hook tape on top of the glue area on the head sensor as shown in picture 2.
1.
2.
Battery use
Open the hatch on the back side by lifting it upwards.
Slide in the coin cell battery underneath the silver holder bridge. Make sure the plus-side of the battery is upwards towards you, and away from the circuit
board. Make sure the battery is set exactly on top of the silver-colored circle underneath the bridge. Don't push the battery too far or you might damage the
electronics.
Remove the battery by sliding it out by pushing it gently from the side on your fingertip or nail.
14
Publicidad
