Publicidad
Battery use
Open the hatch on the back side by lifting it upwards.
Slide in the coin cell battery underneath the silver holder bridge. Make sure the plus-side of the battery is upwards towards you, and away from the circuit
board. Make sure the battery is set exactly on top of the silver-colored circle underneath the bridge. Don't push the battery too far or you might damage the
electronics.
Remove the battery by sliding it out by pushing it gently from the side on your fingertip or nail.
Close the hatch by pressing the sides firmly together to seal the locks. Check that sides are seamlessly connected to each other. The sensor turns on when
battery is applied, but not all the components necessarily do. Switch the sensor off and back on before use.
Switching the sensor on
Switch the sensor on by pressing the on/off- button once slowly and firmly. Red LED light next to the button starts blinking in slow frequency to signal the
sensor is on. If the light blinks in high frequency (in fast pace), the battery is almost empty. Change the battery or ACT Head Impact Tracker might not work as
intended. If the light does not come on at all, try with new battery. If the light is still not turning on at all, or the light turns on but it is not blinking, the head
sensor is not working and should be replaced.
Switching the sensor off
Turn sensor off by pressing the on/off-button twice slowly and firmly. Wait to see one long red LED light signal and then no more blinking to ensure the
sensor is switched off.
Activating tracker mode
- Switch the head sensor on by pushing the on/off button once (1.).
- Push the on/off button one time for about 2 seconds (1 long push), the LED light blinks 3 long blinks to show the tracker mode is activated (2.). Then blinks
slowly (1 blink every 5 seconds) to indicate that the head sensor is on. Please note: when the tracker mode is on, no real time impact information will be sent
to the App. You can download all the impact data recorded by switching the sensor off and back on again, or by returning to normal mode by deactivating
Tracker mode.
1.
Deactivating tracker mode
When tracker mode is on, push the on/off button one time for about 2 seconds (1 long push). The LED light blinks 4 long blinks to show the tracker mode is
deactivated. LED light continues blinking slowly (1 blink every 5 seconds) to indicate the head sensor is on. You can either continue using ACT Head Impact
Tracker on a normal mode or switch off the sensor by pushing on/off button twice.
Push once to switch
the sensor on.
>>>
2.
Push and hold for 2 seconds to
activate the Tracker mode.
8
Publicidad
