Husqvarna Royal 47 Manual Del Operador página 22

(1) ASSEMBLEY
Unfold the handle with care. Avoid
damaging the cables. Tighten the wing
nuts.
Check movement of throttle control.
(2) Mount the rope guide on the handle's
lower right side. Screw the nut on from
below and tighten. Run the starting rope
through the guide.
(3) Assembly of grass collector
Raise the safety flap. Place the grass
collector over the ejection chute. Lower the
grass collector until it is supported by the
lower handle sections and place the safety
flap over the front section of the collector.
(4) Emptying the grass collector
Swing open collector top and remove
grass. See illustration.
(5) Filling with oil
Fill the engine with oil. A bottle of the
correct amount of oil is included with the
mower. SAE 30, SAE 10-30 or SAE 10-40
can be used.
(6) ADJUSTING THE CUTTING HEIGHT
Adjust to the desired cutting height by
means of the lever on the nght side of the
mower.
(7) STARTING AND STOPPING
Place the mower on a flat surface free
from gravel, etc. Fill the tank with petrol.
Either leaded or unleaded petrol can be
used. Do not fill writh petrol while the
engine is running. Any petrol spillage
should be hosea off with water. Take care
that water does not enter the engine.
Connect the spark plug lead.
Choke:
(8) Starting the cold engine
Set the throttle to the «choke» position.
(8) Starting the warm engine
Set the throttle to the «max» position.
Primer:
(9) Starting the cold engine
Push primer bulb firmly 3 times before
starting cold engine. (Also, if engine
stopped because it ran out of fuel, refuel
engine and push primer 3 times).
(9) Starting the warm engine
NOTE: Priming is usually unnecessary
when restarting a wami engine. However,
cool weather may require priming to be
repeated.
(10-11) Pull the blade brake lever all the
way to the upper handle before you start
the engine. The lever is to be held in
position for keeping the engine running.
Releasing the blade brake lever will
stop the engine within 3 seconds.
(12) Start the engine by pulling the starting
handle firmly upwards. Adjust the throttle
to the desired engine speed between the
«max» and «min» settings.
(13-14) Starting first time R47SE
The battery must be charged for 24 hours
before use.
Start procedure:
Pull 2-3 times on the starter handle to
supply petrol to the engine. Release the
starter handle and turn the key in the
direction of the arrow. You willl prolong the
life of both battery and starter if you ensure
that the starter is not engaged for more
than 5 seconds at a time followed by a
pause of 10 seconds before you make a
fresh attempt to start the machine.
(14) Starling R47SE
Start the engine by turning the key in the
oirection of me arrow. Adjust the engine
speed to the desired setting between
«max» and «min».
(15) Running R47S/SE
Forward drive is engaged and disengaged
with the clutch control lever at the top of
the handle. Releasing it stops the fonward
drive automatically.
(10) Stoppitiry the engine R47
Release the blade brake lever.
(11-15) Stopping the engine R47S/SE
First release the clutch control lever. Then
release the blade brake.
(16) OPERATION
Due to engine lubrication limitations, the
mower should not be used on slopes in
steeper than 30®.
(17) Before mowing, objects such as twigs,
toys and stones should be removed from
the lawn.
Avoid running the blade over objects such
as stones, roots, etc., as it may cause
engine damage.
(18) Mow the lawn twice weekly during the
periods of most active growth. Never cut
more than 1/3 of the length of the grass,
especially during dry periods. Mow with a
high cutting height setting the first time.
Examine the result and lower the mower to
the desired setting. Mow slowly or mow the
grass twice if it is very long.
(19) Proceed as follows if the ejection
chute becomes clogged: Remove the
spark plug lead. Remove the grass
collector and clean the ejection chute.
(20) MAINTENANCE
Always remove the spark plug lead
before repair, cleaning or maintenance All
nuts, bolts and screws should be checked
for tightness after 5 running hours. Check
the oil. Push the handle down no farther
than ground level when tilting the mower
for cleaning purposes. This will avoid oil
and fuel spillage.
(21) Hose down or brush off all grass,
leaves, etc., from the mover.
(22) Regularly
Stop the engine and unscrew the dipsticl..
The level should be between FULL and
ADD. Note: the dipstick must be screwed
all the way down in order to indicate the
correct oil level. Avoid filling with too much
oil.
(23) Annually (At end of season)
Sharpening and balancing the cutter blade.
Remove the spark plug lead. Remove
the cutter blade and take it to a service
workshop for sharpening and balancing.
When reassembling the blade ensure that
the retaining washer is flat and not dished
and tighten the bolt to a torque of 26-29
ft/lbs.
(24) Change the oil after each season or
after 25 hours. Run the engine until warm..
Remove the spark plug lead. Remove
the dipstick, open the drain plug
underneath the mower and let the oil mn
out. Refit the plug and fill with new oil. SAE
30, SAE 10-30 and SAE 10-40 may be
used.
(25) Adjust the clutch cable so that the
spring streches 7-10 mm when the clutch
lever is pulled completely back.
The engine brake cable should always be
adjusted to stop the engine within 3 sec.
CAUTION! For adjustment contact your
authorized service dealer.
(26) Loosen screw, remove cover and take
out the air filter.
(27) The filter is made of paper and cannot
be cleaned with petrol or solvents. It
should be replaced with a new filter. If it is
only a little dirty it can be cleaned with
compressed air.
(13)Battery storage R47SE
The battery must be disconnected and
stored in a dry place. Loosen the wing nuts
on the top and lift up the battery. The
battery is disconnected as in the illustration
for «Charging the battery». Note! The
battery must be fully charged before
storage. (Recharging time:24hours)
(13) Charging the battery R47SE
The battery must be disconnected and
plugged into the cable from the battery
charger.
(28) Rear discharge deflector is optional.
GENERAL INFORMATION
Transport
Remove the spark plug lead. Loosen the
cables from the handle before carefully
folding it. Avoid damaging the cables.
Empty the petrol tank. The machine must
be drained of oil and fuel when moving it
by public transport.
Service
When ordering spare parts, always quote
the mower's product No. Always check oil
level after service.
22