AENO GS2 Guia De Inicio Rapido página 8

Preparing Device for Operation
1. Carefully open the packaging and remove the device and its accessories.
2. Clean the device (see "Cleaning and Maintenance").
3. Open the plug (3) and fill the tank with water (see Fig. C).
ATTENTION! Use distilled water only.
Use the supplied measuring cup (7). Do not fill the cup above the "100 ml"
mark.
4. Secure the plug.
5. Insert the plug of the power cord into an outlet. Set the switch (5) to the "On"
position. The steam button indicator (4) will start flashing red.
6. Wait about 40s until the water is heated. When heating is complete, the
steam button indicator will turn solid red.
7. Perform a test run of the device (see "Test Run").
Test Run
When turning on the device for the first time, as well as after a long period of
storage, it is recommended to perform a test run to clean the steamer head of
dust and possible dirt. The test run is the release of the first jet of steam into
the air. It is performed as follows:
1. After preparing the device for use, press the steam button once.
2. Press the button again about 5 seconds after the steam starts.
Operation of the Device
1. After preparing the device for use, point the steamer head at the item that
needs to be steamed. Hold the item with your free hand while wearing the
protective glove.
2. Press the steam button once.
3. When steaming is complete, press the steam button once.
4. Set the switch to the "Off" position and unplug the device.
5. Open the tank plug and drain the remaining water.
6. Allow the tank to dry completely: to do this, the plug must be open.
8 aeno.com/documents