Descargar Imprimir esta página

WAGNER FINISH CONTROL 4000 18V Manual De Instrucciones página 23

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 61
FinishControl 4000 18V
replace the diaphragm if necessary (see section14.2).
8. Do not lay the filled spray gun down.
9. Extraction systems should be installed on-site
according to the local regulations.
10. The object to be coated must be earthed.
11. Caution against dangers that can arise from
the sprayed substance and observe the text
and
information
specifications given by the substance manufacturer.
12. Do not spray any liquid of unknown hazard potential.
13. Before
dismounting
relieve
pressure
14. Remove the battery before carrying out any work on
the unit.
15. Work or repairs on the electrical equipment should only be
carried out by a professional electrician, even if there are
instructions regarding such work in the operating instructions.
No liability will be accepted for improper installation.
16. Maximum load of the case lid 100 kg.
17. Only use parts approved by the manufacturer. The users
bear all risks and liability for using parts that do not meet
the minimum technical requirements.
Safety instructions for the charger and
battery
Only use the tool with BOSCH AMPShare
compatible ProCore 18V batteries with at least
4.0 Ah and suitable chargers. The battery voltage
must match the battery charging voltage of
the charger. Do not charge non-rechargeable
batteries. Otherwise there is a risk of fire and
explosion.
Only use the charger indoors and keep it away from
moisture. Water penetrating into a power tool increases
the risk of an electric shock.
Keep the charger clean. There is a risk of electric shock due
to contamination.
Before every use, check the charger, cable and plug. Do not
use the charger if it is damaged. Do not open the charger
yourself and only have it repaired by qualified specialist
personnel using original spare parts. Damaged chargers,
cables and plugs increase the risk of electric shock.
Do not operate the charger on easily combustible surfaces
(e.g. paper, textiles, etc.) or in combustible environments.
There is a risk of fire due to the heating of the charger during
charging.
on
the
containers
the
spray
attachment,
by
opening
the
container.
The battery is delivered partially charged. To ensure full
battery performance, fully charge the battery in the charger
before first use.
Only use the battery in the manufacturer's products.
This is the only way to protect the battery from dangerous
overloading.
Keep batteries out of the reach of children.
Do not open the battery. There is a risk of a short circuit.
Vapours may also escape if the battery is damaged or used
improperly. Take in fresh air and consult a doctor if you have
any symptoms. The vapours may irritate the respiratory tract.
or
the
If the battery is defective, liquid may leak out and wet
adjacent objects. Check affected parts. Clean them or
replace them if necessary.
The battery can be damaged by sharp objects such as
nails or screwdrivers or by external force. An internal short
circuit may occur and the battery may burn, smoke, explode
or overheat.
Never service damaged batteries. All maintenance of
batteries should only be carried out by the manufacturer or
authorised service centres.
Protect the battery from heat, e.g. also from permanent
sunlight, fire, dirt, water and moisture. There is a risk of
explosion and short circuit.
Operate and store the battery only at an ambient
temperature between -20°C and +50°C. Do not leave the
battery in the car in summer, for example. At temperatures <
0°C, performance may be restricted depending on the unit.
Charge the battery only at ambient temperatures between
0°C and +35°C. Charging outside the temperature range can
damage the battery or increase the risk of fire.
Lithium-ion batteries are subject to the Dangerous Goods
Legislation requirements. The batteries are suitable for
road-transport by the user without further restrictions. When
shipping by third parties (e.g.: by air transport or forwarding
agency), special requirements on packaging and labelling
must be observed. For preparation of the item being shipped,
consulting an expert for hazardous material is required.
Dispatch battery packs only when the housing is undamaged.
Tape or mask off open contacts and pack up the battery in
such a manner that it cannot move around in the packaging.
Please also observe the possibility of more detailed national
regulations.
EN
SAFETY REGULATIONS
17

Publicidad

loading

Este manual también es adecuado para:

243734824372402453687