VEVOR AT-60 Manual Del Usuario página 11

To hold the tape by adjusting TAPE HOLDERS,it is unnecessary
to push the SEPARATOR out of position
When dispensing two rolls of tapes at the same time, it is a must
to feed-in both of its lengths at the same time
Remove the first piece of tape
When the second piece of the tape is removed, both sides of the
tape are also dispensed.
Other Functions
FLEXIBLE TAPE SUPPORT
When you cut the tape longer or cut non-adhesive tape / film,use
FLEXIBLE TAPE SUPPORT in order to avoid the tape falling down.
ASSIST STAND
Based on the tape material or work-piece purpose, use the ASSIST
STAND to move the body of machine towards a lower level.
Replace the Blade Unit
Only Blade is not accepted to be replaced.
It needs to change with the whole Blade Unit.
Turn the POWER SWITCH off.
Remove the BLADE UNIT by releasing the 8LADE UNIT RELEASE
LEVER
Install the new BLADE UNIT into the body.
Push down on the housing firmly until it is locked.
Make sure that the lower blade is positioned properly, turn the
BLADEUNIT over and take a look at the bottom edge of the lower
blade.
- 10 -