VEVOR AT-60 Manual Del Usuario página 8

NOTE:
Always use Tweezers to remove tape.
Whenever you set the tape, make sure that adhesive side of tape is
always faced down.
Set the Tape Length
Make sure that DISPLAY indicating <cutting length>
The cutting length is always indicated in some alphabets like
A,b,C,d,E,F
Set the cutting length.
Set your needed length by using +/- BUTTON.
The cutting length is adjustable between 5 mm to 999 mm.
You can set six different lengths by using SELECT BUTTON.
If you press +/- BUTTON for a short while, the length in changed
to 1 mm.
And if you press +/- BUTTON longer, it shows fast forward.
Caution
The actual length differs from the displayed length depending on
the type of the tape and its condition.
When cutting short length of tape, the length may not cut
consistently or tape is jammed.
Try several test cuts to ensure proper operation.
Mode Setting
1.Manual Mode
Make sure that blue LED LAMP is off.
When the LED LAMP is flashing or turned on, press
AUTO/MANUAL MODE and turn off the LED LAMP
Press the START BUTTON once, the machine will feed-in a piece
of tape then cut it out based on your set length.
To cut another piece, press START BUTTON again.
2.Auto Mode
Make sure that the LED LAMP is flashing.
When the LED Lamp's lights are off, press AUTO/MANUAL
BUTTON and let the LED LAMP flash.
- 7 -