VEVOR AT-60 Manual Del Usuario página 14

E-03 Motor is Stopped
Indicates that the motor is stopped because of overload.
Press the START BUTTON to clear the error message.
Press the REV BUTTON to remove the tape.
Turn the POWER SWITCH off.
Check the BLADE UNIT and TAPE OUTLET carefully.
Clear and take away the spare tape waste or sticky residue by

using TWEEZERS
Do not touch the Blade when you are correcting an error under POWER SWITCH is on.
Turn off the POWER SWITCH and stop using the machine.
If the machine cannot work normally after correcting the error.
It seems that nothing is wrong without any error messages.
Do not use the tape if static electricity generates over 1000V.
It may cause failure to the machine.
Problem
The POWER SMTCH
is on but the machine
cannot run.
After removing a
piece of tape, the next
piece doesn't feed
under AUTO mode.
TROUBLESHOOTING
Possible Cause
The AC CORD is
loosened.
The FUSE has been
blown.
The mode is set to
MANUAL.
Some debris is covering
the SENSORS.
The tape can not go
through the SENSORS.
The tape has extremely
low reflectance.
Possible Solution
Check the AC CORD then plug in the outlet
firmly.
Replace the FUSE.
Stop using the machine immediately even
though the FUSE is blown again after being
replaced.
Set the mode to AUTO.
Remove the debris.
Use SEPARATOR to narrow the tape less
than 15mm.
Do not bring strong illuminants close around
the SENSORS.
Some types of tape may not be used under
AUTO mode.
- 13 -