Ammann APR 4920 Traducción De Instrucciones Originales página 34

3. Operation
3.5 Engine operation – Hatz
3.5.1 Starting the Engine (Manual start)
Machines with electrical starter: Never hand start
with a disconnected battery, this leads to immedi-
ate destruction of the regulator.
Attention
1
•
Set the engine speed lever (1) to full load (MAX).
II.
2
•
Slowly pull out handle (2) with rope, until detectable resistance
can be felt (I.).
•
Allow the rope to run back in, to enable you to utilise the whole
length of rope for the starting procedure (II.).
B5399006.cdr
2
•
Take hold of the handle (2) with both hands.
B5399007.cdr
2
•
Pull the starting rope with increasing speed, until the motor
starts up.
If the motor does not ignite after several unsuccessful
attemps at starting, move the speed control lever back
into stop position and pull the starting rope through
Important
slowly, 5 times. Then repeat the starting procedure.
B5399004.cdr
If the engine starts:
I.
1 – 2 min.
B5399005.cdr
•
Set the engine speed lever (1) to idle (MIN).
•
Allow the engine to run for 1-2 minutes in order to warm up.
31
MIN
1
B5399008.cdr