Publicidad
Idiomas disponibles
Idiomas disponibles
Changing the tool (fig. IV)
Risk of severe injuries.
Pull the mains plug out of the plug
¾
socket before all tooling operations.
The machine must be switched off
¾
and at a standstill.
Changing the cutter
▸
Undo the four screws and take off the cover plate.
▸
Press spindle lock
[2]
flange with front-hole key. Remove the cutter.
▸
Fitting the cutter is performed in the reverse
sequence.
When fitting the cutter, ensure that the
direction of rotation arrows on the cuter
and base plate match.
Adjusting the cutting depth
After a cutter change, the cutting depth must be
checked and adjusted as necessary.
▸
Set the cutting depth adjustment wheel
Max position.
▸
Push the motor part forward up to the stop and
rotate the cutter until a cutting tooth has reached
the most forward point.
▸
Measure the distance from the base plate edge to
the cutting tooth; the dimension must equal 19 mm
in the Max position.
▸
To correct the cutting depth, if necessary, loosen
the lock nut and rotate the setscrew accordingly
(1 rotation =0.7 mm). Retighten lock nut.
Adjusting the angle setting
▸
Position the pivoting fence
▸
Undo screw
and move marking
[18]
is opposite to the 0-mark of the pivoting fence.
Retighten screw.
3
18
WARNING!
and screw off clamping
1
2
[6]
at 0°.
[12]
[19]
▸
Dusts from materials such as lead-based coatings,
some wood species, minerals and metals can be
harmful to health. Touching or inhaling the dusts
can lead to allergic reactions and/or respiratory
disorders in the user or in persons in the vicinity.
Certain dusts such as oak or beech dust are
considered to be carcinogenic, particularly in
combination with additives for wood preserva-
tion (chromate, wood preservatives). Materials
containing asbestos may only be machined by
qualified persons.
— Use a dust extractor, if possible.
— Ensure good ventilation of the place of work.
— We recommend the wearing of a respirator with
filter class P2.
Observe the applicable regulations in your coun-
try for the materials to be machined.
The internal dust extraction prevents significant mess,
high dust levels in the breathing air and simplifies
disposal.
Only work with attached chip discharge adapter or
extraction adapter.
Push the dust bag
.
[16]
to the
Regularly empty the dust bag so that dust capture
remains ensured.
For optimum dust extraction, use a vacuum cleaner.
Würth supplies suitable vacuum cleaners. The device
can be directly connected to the socket of a Würth
vacuum cleaner with automatic remote control. This
vacuum cleaner is started automatically when the
device is switched on.
Maintenance and cleaning
until it
▸
Unplug prior to carrying out any work on the
device.
▸
Maintain the power tool and ventilation slots
clean to ensure effective and safe working.
Dust extraction
on to the extraction adapter
[17]
WARNING!
Danger posed by electric current.
Carry out maintenance and cleaning
¾
work on the device only when the
mains plug has been removed.
CAUTION!
Dusts from materials can be harmful to
health.
Use a dust mask or respirator.
¾
Publicidad
