Amica UM130.3 AA Instrucciones De Operación página 45

INSTALLATION AND OPER-
ATING CONDITIONS OF THE
APPLIANCE
This rerigeration appliance is intended or use as a built-in appliance.
WARNING: Keep ventilation openings, in the appliance enclosure or in the
built-in structure, clear o obstruction."
Installation beore using the appliance or the rst time
• Take the product out o the package, remove the scotch tape protect-
ing the door and the equipment. Any remaining adhesive stains may
be removed with a mild washing agent.
• Do not throw away the polystyrene elements o the packaging. I it is
necessary to transport the ridge-reezer, pack it in the polystyrene
elements and lm as well as protect ing it with scotch tape
• Clean the interior surace o the ridge- reezer and the elements o
the equipment with a washing agent dissolved in lukewarm water,
then wipe it dry.
• Place the ridge-reezer on an even, at and stable surace, in dry,
aired and shaded room, ar rom the heat sources such as: oven,
hob, central heating radiators, central heating pipes, hot water in-
stallation, etc.
• On the exterior surace o the product may be a protective oil, this
oils should be removed.
• Make sure the appliance is placed in a horizontal position by screwing
in the 2 adjustable ront legs (g. 3)
• To ensure that the door opens reely, the distance between the side
o the appliance (on door hinges side) and the wall is shown on gure
5.*
• Ensure adequate ventilation o the room and ree air circulation rom
all sides o the appliance (g. 6).*
• WARNING: Keep ventilation openings, in the appliance enclosure or
in the built - in structure, clear o obstruction
Minimum distances rom the heat sources
• rom the electric gas and other ovens - 30 mm,
• rom oil or coal red ovens - 300 mm,
• rom built-in ovens - 50 mm
I there is no possibility o ensuring the above- mentioned distances,
provide an appropriate insulation board.
Warning:
• The rear wall o the rerigerator, in particular, the condenser and oth-
er elements o the cooling system must not contact other elements,
which may damage them, (e.g. central heating pipes and the water
supply pipes).
• It is orbidden to readjust or modiy any parts o the unit. It is crucial
not to damage the capillary tube visible in the compressor recess.
The tube may not be bent, straightened or wound.
• I the capillary tube is damaged by the user the guarantee will be
void (g. 8).
- 45 -