Bras RE.COR.D. 51 Manual De Instrucciones página 14

EN GLIS H
R E . C O R . D . 5 1 & 5 2 - 1 0 2 & 1 0 3
pulling it out.
6. 2 CLEANING
IMPORTANT
Do not attempt to wash any machine components in a
dishwasher.
ATTENTION
Before any disassembly and/or cleaning procedure make
sure that the dispenser is disconnected from its power
source.
1 Prepare at least one litre of a mild cleaning solution of warm
(45-60 °C 120-140 °F) potable water and dishwashing
detergent. Do not use abrasive detergent.
Important: if present, follow label directions, as too strong a
solution can cause parts damage, while too mild a solution will
not provide adequate cleaning.
IMPORTANT
In order to prevent any damages to the dispenser use
only a detergent suitable with plastic parts.
2 Using a brush, suitable for the purpose, thoroughly clean all
disassembled parts in the cleaning solution.
ATTENTION
When cleaning the machine, do not allow excessive
amounts of water around the electrically operated
components of the unit. Electrical shock or damage to
the machine may result.
3 Rinse all cleaned parts with cool clean water.
figure 6
6. 3 SANITIZING
Sanitizing should be performed immediately prior to starting the
machine. Do not allow the unit to sit for extended periods of time
after sanitization.
1 Wash hands with a suitable antibacterial soap.
2 Prepare at least one litre of a warm (45-60 °C 120-140 °F)
sanitizing solution (100 PPM available chlorine concentration or
1 spoon of sodium hypochlorite diluted with 2 litres of water)
according to your local Health Codes and manufacturer's
specifications.
3 Place the parts in the sanitizing solution for five minutes.
4 Place the sanitized parts on a clean dry surface to air dry.
5 Wipe clean all exterior surfaces of the unit. Do not use
abrasive cleaner.
6. 3. 1 ASSEMBLY
1 Assemble the mixing devices by reversing the disassembly
steps.
IMPORTANT
Pay attention to properly install the rubber gasket on the
steam aspiration rings.
2 Assemble the front cover, the product outlet pipes and the
drip tray.
7 ROUTINE MAINTENANCE
ATTENTION
In case of damages, the power cord must be replaced by
qualified personnel only in order to prevent any shock
hazard.
1 Daily: inspect the machine for signs of water leaks and
verify if they are due to water tank overflow. On the contrary a
service call is required.
2 Monthly: perform a decalcification cycle of the dispenser.
Use original spare parts only supplied by the manufacturer.
7. 1 DECALCIFICATION CYCLE OF THE
DISPENSER
Drain water from the tank and fill it with two litres of fresh water
and a decalcification agent in the quantity provided by the
manufacturer. Insert the tank into its housing and put in position
the suction pipe and the water filter. Dispense at least one glass
of solution from both the circuits. Wait at least ten minutes
without any dispensing to allow to the solution to react.
Dispense alternatively all the decalcification solution contained
in the tank. Remove the tank from its housing and drain the
remaining solution. Clean it and refill it with fresh potable water.
Remove every trace of solution from the suction pipe and the
water filter. Replace the tank into the machine and install
properly the water filter. Dispense all the water.
14