Publicidad
Idiomas disponibles
Idiomas disponibles
01 - Central Shaft
02 - Central Shaft Pin
3. INSTALLATION AND PRE-OPERATION
3.1 Installation
3.1.1 Placing
Your appliance must be installed in an aligned, non-slip,
stable surface with 850 mm of height.
23 5/8"
800mm
Installation
FRONT SIDE
3.2 Electric Installation
This equipment has been designed for 110/220 V (50 or
60Hz) or 220 V (50Hz). When you receive the equipment
check tension printed in the tag on the electric cable.
If necessary, adjust the equipment to the desired voltage.
To do so, remove the Rubber Lid located at the bottom of
the Equipment Base No. 09 (Pic.01) and adjust the Selector
Switch to the desired tension.
The cord has a plug with 3 pins, and the central pin is
intended to the grounding. It´s mandatory that the three
points are connected before starting the appliance.
4
PICTURE 02
PICTURE 03
1000mm
19 7/10"
Area
Make sure the power grid where the appliance is
installed is compatible to the tension is compatible with
the tension indicated in tag in the feeding cable.
01
3.3 Hydraulic Installation
It is recommended to install the machine near a drain or
02
channel the Waste Outlet. It is also necessary to install a
faucet (diameter ¾) with tap water directly on the product
to be stripped. Alternatively, it is possible to pick up water
from another faucet through the water inlet pipe.
NIPPLE
Water entrance to
be connected to
the Nipple.
WATER EXIT PIPE
For water and
residues.
Install the
machine near a
water sink.
The water outflow jet shall not drop beyond the disc centre
as shown on Picture 05.
The water outflow shall not exceed 2.5 litres per minute.
3.4 Pre Operation
Before to use the equipment all parts to be in contact with
the product shall be washed with water and neutral soap
(see item 3.3 Cleaning).
Make sure the equipment is firm on its working placv.
Before starting processing, the products must be clean,
without soil and without sand.
PICTURE 04
PRODUCT
ENTRANCE
It is mandatory
to let water
flow directly on
the product.
PICTURE 05
WATER ENTRANCE
WATER OUTFLOW JET
DISC
Publicidad
