Aiwa NSX-A111 Manual De Instrucciones página 10

1
2
POWER
b—
Press TUNER/BAND repeatedly to select the
desired band.
FM ~ AM
r---1
When TUNER/BAND is pressed while the power is off, the
power is turned on directly.
To select a band with the remote control
Press BAND while pressing SHIFT,
Press <4 DOWN or > UP to select a station.
Each time the button is pressed, the frequency changes.
When a station is received, "TUNE is discrlaved for 2 seconds.
During FM stereo reception, ([[0}1] is d~sp~yed.
([[011)
TUNE
To
search for a station quickly (Auto Search)
Keep -
DOWN or > UP
pressed until the frequency starts
to change rapidly. After tuning in to a station, the search stops.
To stop the Auto Search manually, press +
DOWN
or ~
UP.
The Auto Search may not stop at stations with very weak
signals.
When an FM stereo broadcast contains noise
Press MONO TUNER on the remote control while pressing SHIFT
so that "MONO" appears on the display.
Noise is reduced, although reception is monaural.
To restore stereo reception, repeat the above so that "MONO
disappears.
To change the AM tuning interval
The default setting of the AM tuning interval is _10 kHz/step. If
you use this unit in an area where the frequency allocation system
is 9 kHz/step, change the tuning interval.
Press
POWER
while pressing P.
To reset the interval, repeat this procedure.
m
When the AM tuning interval is changed, all preset stations are
cleared. The preset stations have to be set again.
The unit can store a total of 32 preset stations. When a station is
stored, a preset number is assigned to the station, Use the preset
number to tune in to a preset station directly.
7 Press TUNER/BAND to select a band, and press
- DOWN or - UP to select a station.
2 Press 11 SET to store the station.
A preset number beginning from 1 in consecutive order for
each band is assigned to the station.
Preset number
3 Repeat steps 1 and 2.
The next station will not be stored if a total of 32 preset stations
for all the bands have already been stored.
m
"FULL! is displayed if you attempt to store more than 32 preset
stations.
Use the remote control to select the preset number directly
1
2
Press BAND while pressing SHIFT to select a
band.
Press numbered buttons O-9 and +1 O to select a
preset number.
Example:
To select preset number 20, press +10,
+10
and
0,
To select preset number 15, press
+10
and 5,
Selecting a preset number on the main unit
Press
TUNER/BAND
to select a band. Then, press b
PRESET
repeatedly.
Each time k
PRESET is
pressed, the next ascending number
is selected.
To clear a preset station
Select the preset number of the station to be cleared. Then, press
9
CLEAR,
and press 11
SET
within 4 seconds.
The preset numbers of all other stations in the band with higher
numbers are also decreased by one.
10
ENGLISH