Publicidad
Idiomas disponibles
Idiomas disponibles
INSTALLING & CLEANING FOAM SLEEVE FILTER
Installing Foam Sleeve Filter
1. Verify that the power cord is disconnected from the outlet. (fig. 1)
2. Remove power head and place in upside down position. Follow instructions to remove cartridge filter.
3. Carefully slide foam sleeve filter down over the filter cage making sure the whole cage is covered. (fig. 2 & 3)
4. Replace the power head on to the container.
Cleaning Foam Sleeve Filter
1. With the removed power head in the upside down position, carefully remove foam sleeve filter. (fig. 4)
2. Use a mild soap and water solution to wash foam sleeve filter and rinse with clean water. (fig. 5)
3. Allow filter to air dry before installing and using again.
WARNING:
TO REDUCE THE RISK OF ELECTRIC SHOCK-UNPLUG BEFORE TROUBLESHOOTING
Symptom
Vacuum will not operate
Dust comes from motor cover.
Reduced efficiency and motor/
speed vibration.
2
3
TROUBLESHOOTING
Possible Causes
1) No power supply.
2) Faulty power cord.
3) Container full.
1) The cartridge filter is missing or
damaged.
1) There is a blockage in the nozzle,
hose, or the vacuum inlets. Or the dust
filter is blocked by fine dust.
4
o
Corrective Action
1) Check power supply – cord, breakers,
fuses.
2) Unplug and check the power cord. If
damaged, have it repaired by a professional.
3) Empty container.
1) Attach or replace the cartridge filter.
1) Check nozzle, hose and container inlets
for blockage. Take off the filter and clean it.
Or install new filter.
11
5
Publicidad
