Publicidad
Idiomas disponibles
Idiomas disponibles
English – 12
charging capacity. The flashing LED indicates the next
20 % currently charging.
Once the eBike battery is fully charged, the LEDs ex-
tinguish immediately and the on-board computer is
switched off. The charging process is terminated. The
state of charge can be displayed for 5 seconds by
pressing the on/off button (8) on the eBike battery.
Disconnect the charger from the mains and the eBike
battery from the charger.
WARNING
Do not open any of the components. Service
u
should only be carried out at an authorized
Bosch eBike dealer. Failure to follow above warn-
ing can cause death or serious injury. Refer to your
bicycle manual or component manual for all non-
Bosch drive system components.
Do not submerge your eBike components in wa-
u
ter, or wash with pressurized hose. Your Bosch
drive unit is designed to be water tight to rain water
or non-pressure hose washing.
Do not paint any components of the Bosch drive
u
system as they may cause premature failure of
the component.
0 275 U07 3CX | (21.03.2023)
When the battery is disconnected from the charger,
the eBike battery is automatically switched off.
Note: If you have charged the battery on the eBike,
carefully close the charging socket (6) with the
cover (14) after charging, so that no dirt or water can
get in.
If the charger is not disconnected from the eBike bat-
tery after charging, after a few hours the charger will
switch itself back on, check the state of charge of the
eBike battery and begin the charging procedure again
if necessary.
Maintenance/cleaning
After-sales service and advice on using
products
If you have any questions about the eBike and its
components, contact an authorized bicycle retailer.
For contact details of authorized bike dealerships,
please visit www.bosch-ebike.com.
Please contact an authorized bicycle dealer if the
eBike battery is no longer working.
Bosch eBike Systems
Publicidad
